In stock
Only 2 left
SKU
HX316C10FB/4

HyperX Fury Black 4GB DDR3 1600MHz DIMM Memory

HyperX Fury Black 4GB, DDR3, 1600MHz (PC3-12800), CL10, DIMM Memory - HX316C10FB/4
£33.04 £27.53

HX316C10FB/4 

4GB 512M x 64-Bit DDR3-1600 CL10 240-Pin DIMM
 
HyperX HX316C10FB/4 is a 512M x 64-bit (4GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 1Rx8 memory module, based on eight 512M x 8-bit DDR3 FBGA components. This module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the PnP Timing Parameters section below. 
 
 
 
Features
 
• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), single sided component
More Information
Manufacturer
Kingston
Model
HyperX Fury
Memory size
4 GB
Memory Speed
1600MHz
Device Type
DDR3
Form Factor
SDRAM
CAS Latency
CL10
Rank
No
Voltage
1.5V
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
To Top